ZTM02 air booster valve (2x booster pump)

Consult Now

客服电话 18815239758

Product Model: ZTM02 Air Boosting Valve Air Boosting Pump

Boost ratio: 2:1

Drive air pressure: 3-8 bar

Rated boost pressure: 16 bar

Gas consumption: 580L/min

Flow rate: 580L/min

Interface size: NPT3/8 (both inlet and outlet and drive port are the same)

Size: 346 * 86 * 93

Material: Stainless steel and aluminum alloy

The Feinte ZTM02 air booster valve and air booster pump are products independently developed by our company through the introduction of foreign technology. The principle of an air pressure boosting valve is to use the low pressure of a large area piston to generate high pressure of a small area piston. The product has the following characteristics.

1. Easy to adjust: Within the pressure range of the boost valve, adjusting the intake pressure can control the pressure and flow after boosting.

2. Automatic pressure maintenance: Regardless of the reason for the pressure drop, the Fuente air boost valve will automatically start to supplement the pressure and maintain it at twice the initial pressure.

3. Reliable operation: It is driven by gas and can be used in various explosion-proof places without electric sparks.

4. Easy maintenance: In general, just pay attention to replacing the sealing ring.

5. High cost-effectiveness: achieving zero set pressure consumption. The year-on-year pressure is much cheaper than the price of electric booster pumps.

Places such as air conditioning coil testing, valve airtightness testing, coordinate measuring instruments, inkjet printers, and insufficient cylinder clamping force.
Individual or partial devices in the gas path require high pressure.
2. The pressure in the main air circuit of the factory decreases, and a booster pump is used to provide high-pressure gas to maintain the normal operation of the pneumatic device.
3. Large caliber cylinders cannot be configured, but the output force must be ensured.
4. Pneumatic remote operation requires pressurization to compensate for pressure loss.
5. It is necessary to increase the hydraulic pressure of the linkage cylinder.
6. I hope to shorten the time it takes to inflate the gas cylinder to a certain pressure.
7. Used for airtightness testing.
8. Used for filling various gases.