Mobile phone: 18815239758 (same as WeChat)
Phone: 0576-89881178
Phone: 0576-89825885
How to select a compressed pneumatic booster pump for laser cutting machine:
Booster pump, pneumatic booster pump, gas booster pump
What is the driving pressure at the customer's site? Pneumatic booster pumps generally require a driving air pressure of 2-8 bar,
2. To what pressure should the on-site air/nitrogen be pressurized? The cutting effect is better and more perfect.
What is the displacement of the air compressor on site? The driving air consumption of pneumatic pumps is generally 700-1000L/min
What is the required output flow rate of the pneumatic booster pump in liters per minute? The standard flow rate generally needs to be selected according to the requirements of the laser cutting machine manufacturer. It depends on the actual size of the nozzle.
5. Does the customer have a gas storage tank on site? The pressure boosted by the pneumatic booster pump can be stored in a gas storage tank for use by the cutting machine. The pressure resistance value of the gas storage tank should be sufficient and exceed the rated output pressure of the pump
What is the power of the on-site laser cutting machine in watts?
What is the final blowing aperture of the laser cutting machine on site in mm?
Note: If the customer is unclear about their traffic requirements. We can use a nitrogen cylinder to reduce the pressure to the desired level and see how long the next 40L nitrogen cylinder can last. We can help the customer calculate.
The above are the specific requirements for selecting an air booster pump for laser cutting equipment. Please refer to them.
Fax: 0576-89888385
Address:4th Floor, Building 2, No. 78 Huibin Road, Xinqian Street, Huangyan District, Taizhou City, Zhejiang Province
Email: vic@tz-fet.com
