What kind of driving air source is needed for pneumatic compressed air booster pump

What kind of driving air source is needed for pneumatic compressed air booster pump

With the advancement of technology and the rapid development of industry, pneumatic compressed air booster pumps have gradually taken the stage. With decades of development, the variety of pneumatic compressed air booster pumps is diversified and the matching is more humane. What kind of driving air source is good for various pneumatic compressed air requirements? In this article, the editor will give you a brief introduction.

Firstly, it depends on whether the manufacturer's technology is mature and whether the equipment in the factory is advanced. There are several factors that affect the range value of driving pressure, such as the Fuente ZTV02, which has a driving pressure of 1.5-8 bar. Its technology and precision equipment ensure that it can work normally at 1.5 bar. Other manufacturers require a 3bar drive because the precision of technology and equipment does not meet the standards, which requires the downward drive to maintain above 3bar, resulting in a decrease in the overall range value of various pneumatic compressed air booster pumps, and thus a decrease in the boosting area of the pneumatic compressed air booster pump. There are differences in technology and equipment.

Secondly, there is a difference in the size of the booster pump. For example, ZTM02 is a small flow pneumatic compressed air booster pump with a cylinder diameter of 80MM and a length of 346MM. Under full load operation, the air consumption is 580L/min (when driven at 6bar), and the compressed air being pressurized requires an air compressor displacement of at least 1.2M/min to meet the working requirements of ZTM02. ZTV02 is a high flow pneumatic compressed air booster pump with a cylinder diameter of 160MM and a length of 400MM. Under full load operation, the air consumption is 1200L/min (when driven at 6bar), and the compressed air to be pressurized requires an air compressor displacement of at least 2.5M/min to meet the operation of ZTV02.

Summary: What kind of driving air source is needed for a pneumatic compressed air booster pump depends on the air consumption of the booster pump. The driving air pressure is between 6-8 bar, and the higher the purity, the better the service life of the booster pump. In order to better use the booster pump, please contact the sales engineer. Do not only look at the boost ratio or boost flow rate, but also consider the actual working conditions.

空气增压泵Compressed air boosting system