How to select pneumatic booster pumps and pneumatic booster equipment?

Firstly, pay attention to the pressure and flow rate used

The working pressure of pneumatic booster pump and pneumatic booster equipment refers to the pump output pressure and flow rate when the driving (air compressor) is 0.6Mpa. If the larger output pressure of the pump is greater than the required working pressure, protective measures should be considered (note: especially for pressure testing of container pipelines, caution and protection should be taken). For larger output pressures, please refer to the "Approximate Ratio Table of Static Driving Gas Pressure and Output Hydraulic or Air Pressure" in the product catalog. The selection of pneumatic boosting equipment or power units is consistent with that of pumps. For the working flow rate, please refer to the "Performance Curve Chart" in the product catalog, or choose a suitable pump based on sales engineering recommendations.

Secondly, the pressure and flow rate of the driving gas source.

The driving pressure used by pneumatic booster pumps and pneumatic booster equipment during continuous operation should not exceed 0.8Mpa, and during intermittent operation, it should not exceed 1.0Mpa. At the optimal performance state, the air consumption of the pneumatic pump should be calculated based on the cylinder diameter, stroke, and reciprocating times of the pump.

Furthermore, transporting liquid media

The liquid medium conveyed by the pneumatic booster pump is a key consideration in the selection of pneumatic booster pumps. The material of the hydraulic part and the hydraulic sealing ring are determined by the liquid medium being transported. Pumps can use oil, emulsion, water, and most liquid media. The main hydraulic sealing rings of standard pumps are made of rubber and polyurethane, and the one-way valve seat is sealed with PTFE. Other sealing materials include fluorocarbon and ethylene propylene, which are mainly used for conveying special media. If there are special corrosive requirements, it is necessary to communicate with Fuente manufacturer.

Attachment: Acceptable volume and weight of pneumatic booster products for certain applications, the external dimensions and weight of the pneumatic booster pump and power unit should also be considered in conjunction with the customer's on-site working conditions.

Fuente brand pneumatic booster pump can choose a suitable pneumatic booster product for your use based on the above requirements.

How to choose a pneumatic booster pump? How to choose pneumatic boosting equipment? What parameters do you need to know to ensure that the pneumatic booster pump you ordered is in optimal working condition? Perhaps you have a rough answer in your mind based on the above introduction.