Mobile phone: 18815239758 (same as WeChat)
Phone: 0576-89881178
Phone: 0576-89825885
How to adjust the flow rate and pressure of the gas booster pump?
With the advancement of technology, various fields have requirements for the use of gases and the pressure and flow rate of precious gas recovery, such as gas circulation, gas recovery, etc. How to solve several problems? Below, the gas booster pump editor will give a brief introduction.
Laboratory special gas closed cycle testing requires the use of a gas booster pump for circulation. If the air pressure is the same in the same closed pipeline, circulation cannot be carried out, and there must be a section that forms a pressure difference. In this case, a Fuente gas booster pump is needed. Inserting a gas booster pump into the circulation pipeline, when it is turned on, the inlet will create suction to form a low pressure, and the high-pressure outlet will form a high pressure after being compressed by the high-pressure cylinder. When a high and low pressure difference is reached, the gas will automatically circulate to form a complete circuit.
How to control the flow and pressure of gas circulation and recovery booster pumps that can meet both requirements? This still needs to be addressed from the perspective of the driving gas source. For example, the ZTA10 gas booster pump is a 10 fold booster pump, and the pressurized gas is 10 times the driving pressure. Adjusting the driving pressure can adjust the pressurized gas pressure. How to adjust the flow rate after pressure regulation? Let's introduce ZTA10. When the intake pressure is the same as the driving pressure, the driving pressure consumption is ten times that of the pressurized gas. By adding a relief valve to the driving port, the driving flow rate can be adjusted to control the flow rate of the pressurized gas.
Fax: 0576-89888385
Address:4th Floor, Building 2, No. 78 Huibin Road, Xinqian Street, Huangyan District, Taizhou City, Zhejiang Province
Email: vic@tz-fet.com
